StarTech.com VSEDIDHD, Instruction Manual

Instruction Manual

10

6.  Press and hold the 

EDID copy

 button on the EDID Copier until the 

Status LED

 starts 

to flash green. When you release the 

EDID copy

 button, the 

Status LED

 will then 

flash green and red alternately, indicating that the EDID Copier is actively copying 

the display’s EDID settings. The LED will then light blue, indicating that the EDID 

copy process has successfully completed.

Use Memory mode to output copied EDID settings.

1.  Set the 

Mode switch

 on the EDID Copier to 

Memory mode

.

2.  Set the 

Rotary dial 

on the EDID Copier to the setting where you’ve saved the EDID 

that you’d like to output. 

3.  Set the 

Dip switches

 to your desired setting based on the requirements for your 

application (see Dip switches section, page 6).

4.  Connect an HDMI cable (not included) to your video source and to the 

HDMI input 

port

 on the EDID Copier.

5.  Connect an HDMI cable (not included) to the EDID Copier’s 

HDMI output port

 and 

to the video input port on the third-party equipment that is causing the disruption.

6.  Verify the signal has been corrected by viewing your display.

EDID emulating

Use PC mode to emulate the EDID settings for your display connected to a 

computer.

1.  Set the 

Mode switch

 on the EDID Emulator to 

PC mode

.

2.  Use the included screw driver to set the 

Rotary dial

 on the EDID Emulator to the 

position that corresponds with your desired resolution (see the PC mode tables in 

the Rotary dial section, page 4).

Note: 

Positions

 0 

and 

1

 are used for EDID copying applications (see the PC section 

of EDID copying, page 8).

3.  If your video source is HDMI, use the included screw driver to set 

Dip switch

6

 in the 

OFF

 position (down). 

   or 

If your video source is DVI (using an HDMI adapter), use the included screw driver to 

set 

Dip switch 6

 to the

 ON

 position (up) and proceed to step 6.

4.  If your video source is HDMI you can set the audio EDID to your desired setting. 

If you’d like to emulate your EDID to support 7.1-channel sound, set 

Dip switch

1

 to 

the 

ON

 position (up) and 

Dip switch 2

 to the 

OFF

 position (down). 

or 

If you’d like to emulate your EDID to support 5.1-channel sound, set

 Dip switch

1

 to 

the

 OFF 

position (down) and 

Dip switch

 2 to the 

ON

 position (up). 

or 

If you’d like to emulate your EDID to support 2-channel sound, set 

Dip switch

1

 and 

2

 to the 

OFF

 (down) position.