Crank Bearings Replacement
/ N C . _
NOTE:
If necessary,
GENTL
Y
tap the crank
pulley to aid in remov-
ing the crank pulley
from the crank shaft.
NOTE:
If necessary,
GENTL
Y
tap the crank
pulley keys into place
with
a
rubber mallet.
3.
Loosen the crank belt from the crank pulley. Using 9/16-in. hex head socket wrench and
9/16-in. open-end wrench, remove the four bolts, washers and nuts securing the crank
assembly to the frame. CAREFULLY remove the crank assembly from the frame. See
Diagram 81.
Disassemble the crank assembly:
1.
Using 5/64-in. Allen wrench, loosen the Allen screws on the two pillow blocks. GENTLY
slide the two pillow blocks off of the crank shaft.
2.
Using external retainer ring pliers, remove the two retainer rings from the grooves on the
crank shaft.
3.
CAREFULLY remove the crank pulley and the two crank pulley keys from the crank shaft.
BE CAREFUL not to lose the two crank pulley keys.
Assemble the crank assembly:
1.
Install the crank pUlley on the crank shaft, aligning the two keyways in the crank pulley
with the keyways in the crank shaft.
2.
GENTLY insert the two crank pulley keys into the crank shaft key slots. DO NOT force
the keys into place.
3.
Using external retainer ring pliers, install the two retainer rings in the grooves on the
crank shaft (on either side of the crank pulley.
4.
Install the two pillow blocks on the crank shaft with the Allen screws facing outward (to-
ward the ends of the crank shaft). MAKE SURE the Allen screws in the pillow blocks align
with the flats on the crank shaft.
Elliptical Edge Service Manual
5.28
Summary of Contents for Elliptical Edge
