STAS -
Instructions for use moving floor
33
E. SPECIFIC PROCEDURES
2.4. EMERGENCY CONTROL UNIT
General
In case of electrical faults, the floor system can still be hydraulically operated by hand. Please refer to the manual for
the moving floor system under the paragraph on “emergency provision” or “emergency operation”.
Secondary operation for Cargo Floor
®
For operating the moving floor system, a fixed switch has also been installed in the storage area for the control unit.
Figure 2.4.2.a. – Fixed switch for operating moving floor system
This switch has 3 positions:
I = “load”:
the switch must be kept in this position manually to allow the system to load. If the switch is released, it returns to the
“0” position.
0 = “stop”:
the switch automatically returns to this position when the turning knob is released. In this position the moving floor
system is inactive.
II = “unload”:
the switch must be kept in this position manually to allow the system to unload. If the switch is released, it returns to
the “0” position.