15
3. INSTALLATION
3.1 UNPACKING AND CONTENTS INSIDE
Precautions are mandatory to prevent any damage due to mishandling or water ingress. Manufacturer shall not
be responsible for any such damage during transport, unloading or storage at site.
Please take a few moments to unpack your new HBD-NG range of Smart Storage Solar Inverter according to the
Following steps:
1. Unpack the wooden packing carefully. Be careful as there may be sharp edges or nails. Ensure the unit does
not incur any scratch during unpacking.
2. Use a crane to unload the machine in case of higher capacity machines. Proper lifting hooks have been
provided to lift the machine using a crane as shown below (applicable for larger machines only).
3. Ensure the machine is always lifted vertically without tilting on any side to prevent any damage inside.
4. Check whether unloading or unpacking should be done first in case of large machines depending upon the
condition.
5. Use always a forklift to move the inverters from one location to other location as shown in the figures
above.
6. Ensure the unit is placed on a raised wooden pallet. It will ensure better cable entry through bottom and also
give an increased level of insulation.
7. Verify the contents inside. It should include the SSSI unit, a hard copy of product manual for Installation and
Commissioning which is also, and a warranty card. Please note that any extra accessories such as
communication cable, mounting/ grouting hardware, or termination hardware, is a not a part of supply and is
under the scope of customer or to be bought at extra cost.
8. Go through the rating plate/rating sticker and verify that the model no. matches the model no. that was
ordered. In case of any issue related to model no. or rating, refer to the section 2 of this manual.
9. Please open the doors of the inverter to check there are no hanging wires/ connectors that may have resulted
during the transport. This is just to be sure about the readiness of the unit before being powered up. In case
something does not look okay, please contact the after sales/servicing department or your installer/dealer.
Figure 13
