25
Figure 20
Figure 21
Table 6
Figure 22 : BATTERY AND PV STATUS SCREEN
Basically, Mimic have three 3 lines, each of which has a specific set of data.
The first line shows the mode of operation in which the machine is at that moment of time. The operations
are mains connected, anti-islanding, standalone, boost charging, float charge, bulk charge, charge
absorption, Invrt + Sync and System off. The details and understanding of all these modes have been
explained later on.
nd
The 2 line talks about the existing/ latched faults, if any. All the possible faults have been explained later
in Appendix 1. See Appendix-1 for possible faults and their troubleshooting, otherwise it will declare that
there are no faults in the system.
rd
The 3 line talks about the firmware version that has been uploaded in this machine. It is relevant if the
manufacturer recommends any update to the machine.
The overall Home Screen looks something as below:
5.4.2 BATTERY AND PV STATUS SCREEN
This screen mainly displays the DC side parameters most of them
Battery Parameters. This includes Battery Voltage, Battery Current
(with sign), Solar Voltage and Solar Amps. Given figure along with
the chart explains this.
The location of each of the parameters in detail:
LABEL
SAMPLE VALUE
TEXT DISPLAYED
INFERRED PARAMETERS
B.1
105.6
DC Bus volt
Battery Instantaneous Voltage
B.2
7.8
Batt. Amps
Total current from or into the batteries (positive
value indicates batteries discharging)
B.3
0.5
Solar Volts
Voltage supplied by the solar panels
B.4
0.7
Solar Amps
Current being delivered by solar charge controller
# Press +/- to check the current drawn by other MPPT channels, if they are available
