The Installation drawing of filter A1-
Replace Halogen Lamp
Allow the lamp to cool down before replacing.
• First, remove the lamp cover
• Unscrew the defective halogen lamp and replace it with a new one (power:40W)
• Replace the lamp cover carefully; making sure it’s in position.
Cleaning the Cooker Hood
• To protect the main body from corrosion caused by long term accumulation of dirt,
the cooker heads should be cleaned with hot water and non-corrosive detergent
every 2 months.
• Please do not use abrasive detergent as it will damage the body
• Never immerse the motor and any other electrical parts in water or other liquid.
• Before cleaning, ensure the power is off.
• The carbon filters are neither washable nor reusable and must be replaced every 4 months.
Clean the fan and other surfaces of
the appliance regularly using a cloth
moistened with rubbing alcohol or
non abrasive liquid detergent
Troubleshooting
Fault Cause Solution
Light on, but motor does
not work
Both light and motor do
not work
Oil leakage
The blades are blocked
The capacitor is damaged
Replace capacitor
The motor is damaged
Replace motor
The internal wiring of motor
is cut off/disconnected. An
unpleasant smell may produce
Replace motor
Apart from the above mentioned, check the following:
Light damaged
Replace lights
Power cord loose
Connect the wires as per the
electrical diagram
Outlet and the air ventilation
entrance are not tightly sealed
Take down the outlet and
seal with glue
Leakage from the connection of
U-shaped section and cover
Take U-shaped section
down and seal
