2
2.
INSTALLATION
2.1
Location
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator.
Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly. This unit is not designed for use in
a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 10cm of free space is left at both sides, 10cm at the rear
and 30 cm at the top of the unit. This will allow cold air to circulate around and improve the
efficiency of the cooling process.
2.2
Reversing the Door Swing
Tools Required:
Phillips style screwdriver / Flat bladed screwdriver / Hexagonal spanner
1)
Remove the right top hinge cover .
