STATESMAN TL335LW, Instruction Manual

8

Drainage Channel 

The drainage channel must be cleaned regularly to prevent a build-up of impurities; this can be 

found on the interior back wall of your appliance. Use a damp clean cloth and wipe the channel 

clean, then use a pipe cleaner or similar flexible object to clean the drainage hole to prevent 

blockages.

Going away 

If you are going away and do not want to leave the appliance switched on, switch off at the socket 

and remove the plug from the mains socket ensuring not to pull the cord. Remove any food and 

follow the cleaning instructions in the “Cleaning and Maintenance” section. 

Note: Leave the door ajar as this will prevent odours and mould accumulating in the appliance and 

will allow the appliance to dry completely. 

Power Cut 

In the event of a power cut keep the appliance door closed to maintain the temperature inside.

Bulb Replacement

The internal Light is LED, it is advised to contact a qualified electrician to replace the bulb.

Operating Sounds

You may notice some unusual noises from your appliance, these are perfectly normal, but you 

should be aware of them. 

The compressor can make a buzzing or humming sound when it is running. This can be louder 

when the appliance is first switched on but should become quieter in a few months. Gases flowing 

through the cooling systems can cause gurgling, bubbling or similar sounds. These noises are 

normal and have become more pronounced since the introduction of CFC free gases. Expansion 

and contraction of parts inside the appliance can produce a cracking noise as they rapidly change 

temperature.

Fuse Replacement

This appliance must be earthed. There are 3 screws on 

the plug, remove them and open the shell. Take out fuse 

and replace with a new fuse of the same Amp. Install the 

shell again and tighten the screws.