Warning
Note
V0.969-S16
Particle Trap
®
Cube Operation Manual
Thank you for purchasing the Particle Trap Cube (PT Cube). Although this device is not specified as a high
voltage device according to electrical equipment standards, it uses high AC voltages and we therefore ask
that it be operated correctly after carefully reading this instruction manual. Please store this manual
carefully and utilize it appropriately when required.
Safety Precautions
Because this device uses high internal voltages, there is the possibility that incorrect usage can lead to
physical injury or damage to the product. This company does not accept any responsibility for uses outside
the parameters of the product specifications or failure to follow these safety precautions.
This device does not conform to explsion-proof specifications. Do not install or use it in
locaions or atmospheric conditions where flammable gases or solvent are handled. Doing
so many result in fire or explosion.
Because high voltages are applied to the emitter pin, keep it away from conductive objects
such as your fingers and body, wires, tools, etc. It may cause electrical shock or damage.
Because the tip of the emitter pin is sharp, take sufficient care when handling it. It may
cause injuries.
Do not under any circumstances disassemble, repair, or modify this device. Doing so may
cause an accident or damage.
Connecting, installing, and maintenance must be with the power turned off. Failure to do
so may cause accidents or damage.
Because the fan rotates at high speed when the power is on, do not insert small objects
etc. between the gaps in the guard. Doing so may cause an accident or damage.
Because this device incorporates devices that generate high voltages, avoid installing it in
wet, oily, hot, and humid locations. In particular, avoid using it in locations of high
humidity and condensation.
Be sure to ground the device. Failure to do so can cause deterioration of its neutralizing
characteristics, malfunction, and damage.
If the product does not work anymore or is no longer required, dispose of it in the
appropriate manner as industrial waste.
Carry out wiring and ducting correctly. If done incorrectly, it can lead to diminished
performance and damage.
Because this device generates high voltages, management of operation, maintenance,
etc. should be carried out by a sufficiently knowledgeable and experienced person.
R
1
