8
EN
MAINTENANCE, SPECIFICATIONS
ACCESSORIES, CE DECLARATION OF CONFORMITY
MAINTENANCE
Your tool requires no additional lubrications or maintenance. There are no user serviceable
parts in your tool, battery pack or charger. Never use water or chemical cleaners to clean
your tool. Wipe clean with a dry cloth. Always store your tool in a dry place. Keep the motor
ventilation slots clean.
SPEED SELECTOR SWITCH
The two-speed selector switch (2) enables you to select the appropriate gear with the
optimum speed and torque to suit the application.
WARNING:
When changing the gear ensure the drill is switched off.
To select the low gear (low speed, high torque setting), push the gear selector (2) backward.
The digit 1 on the switch will be displayed.
To select the high gear (high speed, low torque setting), push the gear selector (2) forward.
The digit 2 on the switch will be displayed.
INSERTING AND REMOVING BITS
WARNING:
Remove the battery or set the forward/reverse switch (3) in central (neutral)
position. The drill is fitted with auto spindle lock which means if you try to rotate the chuck
by hand the spindle will automatically lock. This means you only need to grasp the chuck
and rotate the chuck housing to remove or fit accessories.
•
Hold the machine with one hand and rotate the chuck with the other hand.
- To open the chuck, rotate it anti-clockwise.
- To close the chuck, rotate it clockwise.
•
Insert the bit.
•
Close the chuck.
•
Perform a test run to check that the bit is properly clamped in the centre.
Summary of Contents for CTW12-2Li
Page 40: ......
