WATCH DISPLAY
TIMESETTING
A - START/STOP CHRONO BUTTON
B - CROWN
C - SECONDS DIAL
D - RESET CHRONO BUTTON
E - DATE WINDOW
F - 1/10 SECONDS DIAL
G - MINUTE COUNTER
H - SPEED/MPH BEZEL
I - CHRONO SECONDS COUNTER
Locate the crown on your Stauer
watch (see diagram part B). Please
note the three crown positions
(0-1-2) in part B of the diagram.
1. To set the time: Pull the crown
out to position “2” (see diagram part
B which will allow you to position
watch hands for proper time selec-
tion. Rotate the crown clockwise
until the desired time is set.
2. When finished setting the time, push the
crown back to the “0” (zero) position. The
small second hand (dial part C) begins to run.
SETTING THE DATE
1. Pull the crown out to the first position.
2. Turn the crown counter-clockwise to set
the date (Part E).
3. After the date has been set, push the crown
(part B) back to position “0” (zero).
USING THE CHRONOGRAPH
This chronograph is able to measure and dis-
play time in seconds united up to a maximum
of 30 minutes (part G) 59 seconds (part I)
Measuring the time with the chronograph
1. The chronograph can be started and stopped
each time button “A” is pressed.
2. Pressing button “D” resets the chronograph
and the chronograph second hand (part I),
chronograph minute hand (part G) which
return to the zero position.
To adjust the band: Remove equal number
of links from both sides of the closure by
carefully sliding out the pins in each link.
To do this, you will need to use a sharp
pointed tool. Insert it into the recessed
side of the link. With a solid tap, push the
pin out until it is easy to pull the pin using
needle nose pliers. Once the required
amount of links are removed, join the
remaining links together using the removed
pins. It is necessary to secure the pins in
place by making sure that they are flush
with one side of each link. To ensure that
watch is fitted properly, we recommend
that your Stauer watch be handled by a
professional watch repair technician.
INSTRUCTION MANUAL
Stauer Titan
Chronograph Watch
CHRONOGRAPH RESET (INCL. AFTER
REPLACING BATTERY)
This procedure should be performed when
the chronograph second hand does not return
to zero position after the chronograph has
been reset and after the battery has been
replaced.
1. Pull the crown out to position 2.
2. Press buttons “A” and “D”to set the
chronograph second hand to the zero posi-
tion. The chronograph hand can be advanced
rapidly by continuously pressing or holding
down button “A”.
3. Press button “A” to adjust chrono second
hand counter. Then press button “D” to shift
to 1/10 second dial, and then push “D” again
to shift to minute dial and then press “D”
again to end the adjust mode.
4. Once the hands have been set to the zero
positions, return the crown to the normal
“0” position.
Visit us at, www.stauer.com to learn more
about the fantastic benefits of owning a
Stauer Watch!
www.stauer.com
IMPORTANT
FEATURES
- Swiss Quartz Movement
- Chronograph
- Band Width: 23mm
- Wrist accommodations up to 8 ½”
- Case Thickness: 9 mm
- Case Diameter 40 mm
- Titanium Case
- Titanium Band
- Carbon Fiber Dial
Do not push the crown to the normal
position while the chronograph second hand
returns to the zero position. The second hand
stops when the crown is returned to the
“0” position. This position is recognized
as the “0” position.
ADJUSTING CLASPS
