5 Operation
24 / 33
Mobile cutting ring pre-assembly machine
www.stauff.com
5.3 Cutting ring assembly preparation
Insert the assembly studs
1
2
3
4
5
6
Fig. 15: Assembly stud on the pressure cylinder
1 Assembly stud
2 Clip
3 Assembly stud
(mounted)
4 Drill holes
5 Groove
6 Pressure cylinder
u
This is the way to fit the assembly stud:
1. Select the right assembly stud for the tube. Note here the differences
between the light (L) and heavy (S) series.
2. Ensure that the pressure adjustment wheel on the underside of the
machine is on Step „1“.
3. Press power switch on the operating panel at the back.
4. Keep extending the pressure cylinder with the pressure button until
the clip in the groove can be reached.
5. Pull out the clip.
6. Position the assembly stud on the pressure cylinder such that the drill
holes point towards the operator and lie over each other.
7. Insert the clip through the drill holes.
8. Press the return button to fully retract the pressure cylinder.
9. Set the pressure needed at the pressure adjustment wheel. For this,
consult the pressure table ( Section 3.7.4, P. 18).
þ
The assembly stud is installed.
The assembly stud is to be lightly oiled at regular intervals with
the supplied assembly oil. This protect the assembly stud from
wear.
Also note the safety instructions on the oil bottle!
