5 Operation
26 / 33
Mobile cutting ring pre-assembly machine
www.stauff.com
5.4 Pre-assembling the cutting ring
Fig. 17: Cutting ring pre-assembly
u
This is the way to pre-assemble the cutting ring with the machine
switched on:
1. Keep hold of the machine at the hand grip with one hand and, with
the other, the tube on the outside.
2.
CAUTION!
Hand injury during the pressing.
Keep fingers or items
away from the assembling area.
3. Keep actuating the push button until the setting pressure is obtained.
ü
You will hear a slight click and the pressure cylinder extending is
stopped.
4. Keep actuating the return button until the pressure cylinder is back in
the starting position.
5. Press apart the holding devices and remove the tube.
6. Check outcome of the cutting ring pre-assembly:
- as to correct position of the cutting ring
- as to a firm fit
- as to no unwanted deformations
þ
The pre-assembly is over.
Fig. 18: Outcome of the cutting ring pre-assembly
