2 For your safety
8 / 33
Mobile cutting ring pre-assembly machine
www.stauff.com
2.2 General safety instructions
Safety instructions help you to prevent injuries and damage to property.
Ensure that you have read and understood all safety instructions in this
instruction manual.
For safe working, it is not sufficient to only read the general safety
instructions in this section. You must also read and follow the special safety
instructions in all sections concerning your work. Note and follow also the
information and instructions in the reference documents.
The following safety instructions apply generally:
• Comply with the respective relevant national and international safety
regulations regarding health and safety at work.
• Operate the machine only …
– if it is in perfect technical condition,
– safely and aware of the hazards,
– as intended ( Section 2.1, P. 7),
– paying attention to this instruction manual,
– with unchanged, fully installed, properly installed and fully functional
safety devices and
– with properly installed and functioning control.
• Respect all safety markings installed on the machine
• Wear personal protective equipment ( Section 2.8, P. 12).
• Correct immediately any faults that could have a negative effect on your
safety or on safe operation of the machine. Shut down the machine until
the fault is corrected and safeguard it against restarting.
• Work on electrical installations may only be carried out by qualified
electricians. Work on live parts may only be carried out under the
supervision of a second person.
• Be aware of the presence of possible residual energies in mechanical
and electrical components.
• Use spare parts authorised by the manufacturer to replace components.
Unauthorised spare parts can endanger the operating safety.
