6 Operation
SPR-PRC-POC
49 / 72
5.
WARNING! Risk of shearing off and crushing fingers: Ensure
your fingers are not in the assembly area when operating the
machine!
6. Press and hold the tube.
Assembly starts.
Fig. 56: Pressing on the workpiece
The
Ready/Process runs
lamp lights up continuously.
The machine presses the assembly stud against the counter
retaining plate, assembling the cutting ring. The cutting ring is
assembled in line with the assembly type selected.
7.
CAUTION
Note: Slightly more force is required for pressing in
cutting rings of type WDDS due to the internal sealing ring.
8. Checking the product chapter 6.11, p. 53
9. Continue assembly until the production quantity is 0.
The job has been processed.
6.10.2 Assembling a cutting ring in Manual Pressure mode
If the
Manual pressure input
assembly type is selected, no
assembly parameters, which means there is no system check
for assembly. This will invalidate the liability by
Walter Stauffenberg GmbH & Co. KG. The data can be viewed
after assembly. Please refer to chapter 6.11, p. 53
