6 Operation
Machine for cutting ring pre-assembly and final assembly
52 / 72
6.10.4 Assembling a cutting ring in button mode
with foot switch
If the
Manual pressure input
assembly type is selected, no
assembly parameters, which means there is no system check
for assembly. This will invalidate the liability by
Walter Stauffenberg GmbH & Co. KG. The data can be viewed
after assembly. Please refer to
How to assemble cutting rings in button mode with foot switch:
1. Ensure that the correct tool is set up
2. Ensure that button mode with foot switch is set
3. Ensure that the job is set up chapter 6.8, p. 41.
4. Ensure that the workpiece has been prepared chapter 6.9, p. 46.
The
Insert tube, push tube
button is displayed in the
Processing
order
menu.
5.
WARNING! Risk of shearing off and crushing fingers: Ensure
your fingers are not in the assembly area when operating the
machine!
6.
WARNING!
Press the tube against the assembly stud with both hands.
Fig. 59: Pressing on the workpiece
7. Press the foot switch and hold during assembly.
The
Ready/Process runs
lamp lights up continuously.
The machine presses the assembly stud against the counter
retaining plate, assembling the cutting ring. The cutting ring is
assembled in line with the assembly type selected.
8. Checking the product chapter 6.11, p. 53
