SPR-PRC-POC
9 / 72
2 For your safety
• Keep away from moving parts. Wear close-fitting clothes. Tie long hair
back to prevent it from being drawn into the machine. Remove any rings
and necklaces before the work.
• Be aware of the presence of residual energies in mechanical,
hydraulic and electrical components.
2.2 Intended use
The machine for cutting ring pre-assembly and final assembly is intended
exclusively for machine pre-assembly and final assembly of cutting rings on
tube ends in the Light and Heavy Series for outer tube diameters between
6 mm and 42 mm.
The machine is used together with assembly studs and counter
retaining plates specially designed for machine assembly.
The assembly parameters stored in the machine apply solely to the use of
an original STAUFF cutting ring FI-DS-.. in combination with the selected
tube material and the original STAUFF union nut. .
The machine may only be used within the specifications provided in the
chapter “Technical data” chapter 3.2, p. 15 and in compliance with the
maintenance instructions and other instructions in this manual and in the
referenced documents.
No changes, attachments or conversions may be carried out without
consulting the manufacturer. Such modifications could limit the operating
safety of the machine and are considered to be a violation of intended use.
Any use other than the intended use is not permitted.
2.3 Tasks and duties of the operating company
In addition to the instructions and information in these operating instructions,
the general, statutory and other mandatory regulations on accident
prevention and environmental protection also have to be observed.
To ensure safe machine operation, the operating company has to
at least …
• ensure that the machine is only operated as intended, in
proper condition, with all safety devices fully installed and
without damage
• establish the area of application and prepare the corresponding
operating instructions
• always keep the safety markings attached to the machined in a
complete and legible condition
• make the operating instructions available in a complete and legible
form at the operating location of the machine at all times
• instruct the personnel in safe working
