6 Operation
Machine for cutting ring pre-assembly and final assembly
26 / 72
4. If no tool is inserted, the message
Insert tool pairwise!
is shown.
Fig. 14: Menu – Setup > order
5. If the message
Insert tool pairwise!
is shown, insert the tool.
6.
When the tool has been inserted, the
Reference run /
push and hold
message is shown in the menu.
Fig. 15: Menu – Setup > order
7. Press and hold the
Reference run / push and hold
button.
The reference run has been completed.
The machine is ready for operation.
6.4 Warming up the machine
If the machine independently cancels the reference run in cold ambient
conditions and the
Reference run interrupted. Press Acknowledge and
restart!
message is shown on the screen, it is possible that the machine
hydraulics are too cold. In this case, the machine has to be warmed up with
the warm-up program.
