6 Operation
SPR-PRC-POC
33 / 72
6.6 Setting up the tool
ATTENTION
Damage to the machine caused by objects in the assembly area
►
Inspect the assembly area before assembling and remove any tools
and other objects which are not required for the assembly!
How to set up the tool:
1. Check the assembly area and remove any dirt or objects.
Fig. 29: Assembly area empty
2. In the
Setup > order
menu on the control panel, check the
material and set up if necessary.
3. Select the assembly stud and counter retaining plate to match the
desired construction size.
ATTENTION
Damage to the machine caused by different sizes of the assembly stud
and counter retaining plate
►
Ensure that the same tool sizes are used. Using different tool sizes
can result in damage to the tools! Correct cutting ring assembly is
not possible.
