6 Operation
Machine for cutting ring pre-assembly and final assembly
44 / 72
Fig. 47: Menu – Input pad for quantity
2. Enter the quantity.
3. Confirm your entry by pressing the green tick.
The input pad for entering the quantity closes.
The selected production quantity is displayed.
Changing the production quantity automatically resets the
OK quantity to 0!
6.8.4 Setting the pressure for manual pressure
If the
Manual pressure input
assembly type is selected,
no assembly parameters, which means there is no system
check for assembly. This will invalidate the liability by
Walter Stauffenberg GmbH & Co. KG. The data can be viewed
after assembly. Please refer to
How to set the pressure for the
Manual pressure
assembly type:
1. In
Setup > order
menu, press the
Program
button.
The window for program selection opens.
2. Select the
Manual
program.
The
Remove tool
message appears.
