9 Decommissioning
SPR-PRC-POC
69 / 72
9.2 Dismantling
Dismantle the machine as follows:
1. Take the machine out of service and disconnect it from the
power supply.
2. Dismantle protective panels and housing.
3. Remove all operating media.
4. Remove cables and leads.
5. Remove seals from the bearings.
6. Remove any lubricant from machine parts.
7. Sort plastic, electrical and metal parts.
ATTENTION
Solvents and lubricants
Environmental contamination of water and soil
►
When dismantling, collect lubricants and cleaning fluids containing
solvents and oils in suitable receptacles!
►
For disposal, note the safety data sheets for the emulsions,
cleaning agents and lubricants used.
Collect operating media and cleaning fluids containing solvents
in appropriate containers to prevent substances with water-
toxicity from entering the ground or the sewage system!
9.3 Disposal
Following final dismantling of the machine, the operating company has to
dispose of all used materials and components in keeping with the applicable
provisions in the country where the machine is operated.
Particular care is required for disposing of materials which are hazardous to
the environment, e.g.:
• plastic parts
• rubber parts
• electrical parts
• metal parts
• operating fluids and additives
u
How to handle substances with water toxicity:
1. Use appropriate containers to collect, store, transport and dispose
of substances with water toxicity.
2. Dispose of all parts separated by materials at the appropriate
disposal points.
3. Always sort by materials for recycling.
