6
Module Reset :
This option is used to reset the actual number of hours of operation of each lamp,
then it shows 9000 hours of total operation as balance. This is used when you replace a faulty or
failed lamp with a new one. A confirmation message will be displayed saying “ Reset Successful”
for every reset done.
The next option of set up is the “MODE” option. This is used to bring the lamps into Automatic
Mode (or) Manual mode of switching on/off. The LCD displays the information as shown below.
Automatic : If the Auto mode is off, then the lamps need to be switched on off controlled manually
with no reference to real time clock. If the Auto mode is ON then the lamps are automatically
switched on/off based on the time configured already.
To change the configured timings, move the knob clockwise in steps to place the cursor bar on the
desired lamp that you intend to change the timings of. Single click the knob. It will take you to the
time setting screen as shown below.
If the symbol before the numeral is displayed as a colon, then we can change the numerals in
single digits. If a greater than symbol is displayed before the numeral, then we can change the
numerals in steps of 10 digits.
Manual
:
When the manual mode is selected, there is no option to choose the switching on/off of
the lamps by real time clock.
