WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do
not
connect the blue or brown wire to the earth
terminal of the plug.
Important:
If for any reason the moulded plug is
removed from the cable of this power tool, it must
be disposed of safely.
ENGLISH
When the carbon brushes wear below acceptable
matically
service tolerances, the machine will auto
cut
to customer
out. The machine must be sent
service for
address, see the
maintenance for
If the machine should fail despite the care taken
in man
edures, repair
ufacturing and testing proc
should be carried out by an after-sales service
centre for Stayer power tools.
In all correspondence and spare parts order,
please always include the article number given
on the type plate of the machine.
Sharpening Chisels
Good results are only achieved with sharp
chisels; therefore, sharpen the chiselling tools
in good time.
service life of
This ensures a long
the tools and good working performance.
Re-sharpening
Sharpen chiselling tools using grinding wheels
(e.g.ceramic bonded corundum wheel) with a
steady supply of water. Reference values are
shown in the figure. Take care that no annea-
ling coloration appears on the cutting edges;
this impairs the hardness of the chiselling tools.
For
forging
, heat the chisel to between
850ºC and 1050°C (bright red to yellow).
For
hardening
, heat the chisel to approx. 900 °C
and quench in oil. Then anneal in an oven for
approx. one hour at 320°C
(annealing colour = light blue).
5.2.- Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools
into household waste!
According the European Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its
implemen-
right,
tation into national
power tools that are no longer usable must be
collected separately and disposed of in an
Subject to change without notice.
“Service and Customer Assistance” section.
environmentally correct manner.
4
60
ca.60
ca.40
60
20
60
25
25
Summary of Contents for HD21K
