10
Insert the Chassis into the Track
Remove the end plate and limit cam from the top end
of the track. It is held on by set screws from the bot-
tom and sides.
Remove the upper most section of gear rack to allow
you to slide the chassis into the track easily.
Remove any tape or packing material that hold the
glide blocks on the chassis axles.
The chassis can now be inserted into the top end of the
track.
Flip the red RESET/OFF switch to the RESET position.
The lift will beep and the LED indicator will turn red
-
yellow
-
green. The chassis is now ready to be run
down onto the gear rack using the black INSTALLA-
TION SWITCH on top of the chassis.
Run the chassis down the track to the lower limit.
Replace the top piece of gear rack in the track.
Setup Charging System
If you cut your track at the top, slide the charge
strip to where the ends of the track and charge
strip are flush. Secure with a #4 x
3/8”
sheet metal
screw.
Glide Blocks
#4 Phillips Screw
