12
Attach Footrest
Loosen the (4) socket head screws on the
sides of the chassis (2 on each side).
Temporarily remove the front cover from the
footrest assembly (two phillips head screws).
Place the footrest assembly onto the two socket
head screws on the chassis. Use the keyhole pattern
that offsets the footrest assembly toward the top
end of the chassis.
Connect the wire harnesses between the chassis and
footrest assembly.
Level the footrest and tighten the (4) socket head
screws (2 in front and 2 on back).
Note that the ETL
listing is valid only when the track installed at maxi-
mum angle of 45°.
Socket Head
Screws
Front Cover
Phillips Head
Screws
Wire
Harness
Footrest
Assembly