13
Attach Seat
The swivel stop is factory set for a left
-
hand unit. If the
lift is installed on the right
-
hand side of the staircase,
move the seat swivel stop screw to the opposite hole on
top of the footrest assembly.
Place the plastic thrust washer onto the swivel pin.
Seat Swivel Stop Screw
(Shown in LH position)
RH
position
Thrust Washer
Swivel Pin
Place the seat assembly onto the swivel pin. It
may be necessary to lubricate the swivel pin.
Verify the seat swivels the proper direction.
Route the wire harness from the seat control
through the hole in the back of the footrest verti-
cal plate and connect to the mating connector.
Replace the front cover on the footrest
assembly.
Turn on the red RESET/OFF switch to power up
the chassis located on the top of chassis.
The lift can now be operated by the unit
control and the wireless key fobs.
Route Seat
Harness thru hole
Footrest
Vertical Plate
Connect Wireless Receiver
Connect the wire harness from the RF wireless
receiver to the mating connector on the backside
of the chassis. Tuck the excess wiring into the
opening in the chassis and mount the RF receiver
to the chassis with the adhesive foam tape.
Adjust the position of the antennae as necessary.
Antennae
RF
Receiver
Wire Harness
