14
RF Remote Call
-
Send Controls
The two key fobs (transmitters) have been factory programmed.
If you are installing two lifts in the same home, it is not necessary to change the program. However, two
lifts cannot be operated from the remote fobs at the same time. Each transmitter and receiver is unique
and has its own rolling code.
If a key fob needs to be programmed:
1.
Press the program button on the RF receiver 5 times
until the letter
A
is displayed. There should now be a
slow flashing dot on the display.
2.
Press and hold either button on one of the transmitters
and then release when the dot flashes faster.
3.
Repeat step 2 for each additional transmitter.
After the last transmitter is programmed, the LED display
will go off and the transmitters can be tested.
Program Button
Antennae
LED
Display
RF Receiver #74033
Key Fob Transmitter
#74034
