background image

Pg 8 103-010

CARE INSTRUCTIONS

Convertible tops and accessories require special care if you want to get the maximum usage and enjoyment from them.
The following recommendations, if followed carefully, can extend the life of your top or accessory.

1. Hand wash using a mild non-detergent soap such as Ivory. Use a nonabrasive cloth or sponge. Rinse thoroughly.

2. 

DO NOT

 wash in direct sunlight and avoid automatic car washes.

3. When your top is clean, we recommend using “303 Protectant” on both the vinyl top and windows. This product con-
tains a sunscreen that helps protect from the sun’s damaging rays. Stay away from products containing alcohol as it will
cause the fabric and windows to lose their elasticity, thus reducing the life of your top or accessory. If you are unable to
locate “303 Protectant”, please call 1-800-223-4303 for a distributor near you.

4. Direct sunlight and heat are the biggest enemies of the windows. Park in the shade whenever possible. If you must
park in the sunlight, rotate the direction that you park every few days so all windows get even exposure.

5. Our tops are designed so that you may roll up and/or store the rear curtain and side curtains. To prevent scratching of
the windows, be sure that windows are completely clean and free of dust particles. Even a little dirt will badly scratch the
windows. You may want to use a soft cloth when rolling up or storing your windows. Heat may build up on rolled up
windows, so be sure to unroll them frequently. If you roll up the windows at the beginning of summer and leave them, they
may be ruined by fall.

6. 

DO NOT

 open or roll up windows at temperatures below 45 degrees F. This could cause them to crack or break.

7. 

NEVER 

use ice scrapers or snow brushes on vinyl windows.

WARRANTY INFORMATION:

Specialty Top Co. warrants to the original purchaser of any product it manufactures, that the product will be free of defects
in material or workmanship for a period of 90 days from date of purchase. Such obligations under this warranty shall be
limited to the 

repair or replacement

, at Specialty’s discretion, of any assembly or parts which upon examination by

Specialty Top Co. proves to be defective. All defective items must be returned with proof of purchase to Specialty Top Co.,
200 East 64th Avenue, Denver, Colorado 80221, freight prepaid. This warranty does not cover damage resulting from
abuse, misuse, alteration, accident or damage in transit. Specialty’s obligations under this warranty are limited to the
aforementioned repair or replacement of warranty defects for which the return authorization has been received during the
warranty period, and 

SPECIALTY TOP CO. SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL

DAMAGES ARISING FROM BREECH OF THIS OR ANY IMPLIED WARRANTY.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which
may vary from state to state.

If you need assistance or further information, you may contact  Specialty Top Co. at 1-866-487-9944 between the hours of
8:00 AM and 5:00 PM, Monday through Friday, Mountain Standard Time.

Summary of Contents for 103-01X









Reviews: