Q-Logic™ Setup
10.0
16
Joystick Calibration
10.6
Joystick Throw
10.7
Calibrating your joystick will set the range of motion for the axes or re-center it to improve operation.
▪
Follow
Steps 1 & 2
from
Section 10.2
▪
Select
Calibrate
option with the navigation's
Up & Down
buttons, then press the
Right
button.
▪
Programmer will prompt for a calibration of the joystick. Follow directions and move the
joystick around in two circles.
▪
Calibration will be complete. Press
OK
, and when successful, save. Exit the screen and
power cycle the chair.
The Throw is the position where the joystick is stopped in a particular direction. Throw distance is the
maximum distance/angle the shaft can be moved in a particular direction. The throw should be set to
the maximum distance/force the individual utilizing it is capable of.
▪
Once the power cycle from Section 10.8 is complete, follow
Steps 1 & 2
from
Section 10.2
.
▪
Select
Throw
option with navigation's
Up & Down
buttons, then press the
Right
button.
▪
Have the user deflect the joystick with their maximum input force. Adjust the parameter
by pressing the
Plus or Minus
buttons.
▪
When the adjustment is complete, you will be prompted to save the new configuration.
Press
Yes
to save.
CAUTION
Calibration MUST be performed for the joystick. This is a new safety feature
update included in Q-Logic Programmers.
