R-Net™ Setup
11.0
19
Joystick Calibration
11.4
1.
Plug in the R-Net Programming Dongle (previous page) inline with the Omni display
(previous page) and the chair's electronics.
2.
Press the
Mode
button until you reach the OBP (On-Board Programming) menu. The OBP
menu will appear as an hourglass while loading.
3.
With the navigation buttons, navigate to
System
Joystick Calibration.
4.
The system will ask to set each direction independently by pressing towards that specific
direction. For example,
Forward
(0 to 100),
Left
(0 to -100,
Reverse
(0 to -100), and
Right
(0 to
100) Figures are measured in percent.
5.
Calibration will be successful when the axis in the referred direction reaches its maximum and
its counterpart is close to 0. For example,
Forward
will look like:
forward/reverse 90% > left/right 3%
Left
will look something like:
forward/reverse 5% > left/right -87%
6.
When all four axes are calibrated, you will see a green check mark on screen.
7.
Power off the chair, remove the R-Net Programming Dongle, reconnect the Omni display and
power on the chair.
R-Net Proportional Joystick Setup
11.5
1.
Plug in the R-Net Programming Dongle in line with the Omni display and chair's electronics,
then power on your chair.
2.
Press the
Mode
button until you reach the OBP (On-Board Programming) menu. The OBP
menu will appear as an hourglass while loading.
9.
In the
Profiled
menu, configure a profile to use the port for the Multi Joystick.
10.
Power off the chair, remove the R-Net Programming Dongle, reconnect the Omni display and
power on the chair.
•
The chair should now be programmed to recognize the Multi Joystick. Be sure to re-engage
the motors before operation.
