User & Workshop Manual for the Lightning Upholstery
18
9.0 INSTRUCTIONS FOR TRANSPORTING THE LIGHTNING
PUSHCHAIR
The Lightning Pushchair can be folded for transport in the luggage area
of the vehicle. The Lightning Pushchair has been successfully impact
tested and meets the requirements specified in ANSI/RESNA WC/Vol.1,
Section 19, 5.3., prior to May 2002. It may therefore be used as a vehicle
seat.
CAUTION:
When used as a vehicle seat the following instructions must
be followed.
WARNING: ONLY A COMPETENT PERSON SHOULD INSTALL THE TRANSPORTATION
DEVICES
9.1 Preparing Lightning For Transport
9.1.1 Check that the child is correctly strapped in the seat using the
5-point harness. Check that the 5-point harness is properly adjusted.
9.1.2 During transportation the headrest extension must be fitted.
9.1.3 Remove the following if fitted: Work “N” Play Tray, Rain-hood,
Shopping Basket or Sun Canopy.
9.2 Attach The Set Of 4 Tie-Down Kit Brackets
This Instruction is specific to the attachment of Tie-Down hardware for the Lightning
Pushchair.
WARNING: FAILURE TO ATTACH THE HARDWARE AS DETAILED COULD LEAD TO
SERIOUS INJURY OR DEATH.
9.2.1 TOOLS
• 3/16” T-handle Allen.
9.2.2 CONTENTS
4 - Tie-Down assemblies and each include:
• 1 - Handle Threaded Clamp (HTC).
• 1 - Through Clamp (TC).
• 4 - 1/4-20 x 3/4” Socket Head Cap Screws
9.3 Assembly Instructions
9.3.1 Separate the 4 TCs from the HTCs by removing the four screws.
9.3.2 Apply adequate amount of Loctite to each screw.
9.3.3 Loosely position the HTC and the TC to the front left and right bars
as shown:
• LT14 & LT16 - (Fig. 1)
• LT11 - (Fig. 2)
9.3.4 Loosely position the HTC and the TC to the rear left and right bars
as shown:
• (Fig. 3)
9.3.5 Tighten all clamp screws to 100 inches pounds torque (metric: 11Nm).
