+44 (0) 1329 239 679
sales@steam-e.com
www.steam-e.com
GUM REMOVER
Operating Instructions - June 2018
Maintenance
Warning Indicators
De-scaling
There are three LED lights on the top of the machine: for battery, fluid levels and tap setting:
Battery:
The Battery LED will flash continually, indicating a charge is required.
Fluid:
The Fluid LED will illuminate solid red when the fluid reservoir is empty. The power will automatically be cut
when the fluid reservoir is empty.
Tap:
The Tap LED will illuminate solid red when the machine is operated in the tap setting. The Tap LED will flash
continually after 50 days of no activity or 100 hours of use to indicate that a de-scale is required.
The internal heating element can have a build-up of lime-scale due to the operating temperature and a variety in water
hardness. The rinse LED will flash continually after 50 days of no activity or 100 hours of use to indicate that a de-
scale is required.
Note:
Ensure machine is empty of chemical. Ensure both tubes are connected to the heater and the hose is plugged
into the machine.
1. Add descaler (as per manufacturers instructions) into the internal reservoir.
2. Push on the tap setting then both power swicthes to the
ON
position.
3. Run for a minimum of 5 minutes which will descale the machine and reset the descale timer. Make sure you empty
the machine of all descaler, add fresh water and run for 1 minute to remove all trace of descaler.
All three lights will flash together
if the heating cartridge reaches more than 170ºC (320º F) or if the heating unit is
not correctly attached.
To Reset this error code of
three flashing LEDs:
1. Turn off both power switches
2. Set the switch to
TAP
3. Turn both power switches on
4. After seeing fluid run for at least 10 seconds turn the
TAP
switch to
STEAM
If the three lights are still
flashing:
1. Turn off both power switches
2. Disconnect all extension poles from the machine, including the heater unit.
3. Re-attach each extension pole and the heater unit
making sure that each connector is aligned correctly.
4. Set the switch to
TAP
5. Turn both power switches on
6. After seeing fluid run for at least 10 seconds turn the switch to
STEAM
Only use a Steam-e
®
de-scale solution to prevent damage to the Gum Remover.
Only use setting
TAP
when running de-scale solution and be certain to follow
the instructions on the de-scale solution and make sure you have read and fully
understand the Material Data Safety Sheet instructions.
