+44 (0) 1329 239 679
sales@steam-e.com
www.steam-e.com
GUM REMOVER
Operating Instructions - June 2018
STEP 4: Add the Gum Removal Solution
Empty the concentrated gum removal solution into the fluid
reservoir.
Fill the remainder of the fluid reservoir with clean cold water.
To maintain the correct ratio of water to solution, do not
refill the fluid reservoir or add solution until the Fluid LED
indicates that the fluid reservoir is less than 10% full.
STEP 6: Remove the gum
Note:
If you are cleaning a carpet or other material surface,
we recommend testing a small area before using this
solution to ensure you are satisfied with the result.
Place the brush on the piece of flattened gum and wait for
approximately 3 seconds to soften first.
STEP 5: Start the machine
Both power switches need to be in the
OFF
position.
Push the switch on the machine to .
Push the
ON/OFF
switch on the machine to
ON
position and
now push the handle switch to the
ON
position.
Now you will see the battery LED
will be red and the tap LED
will be red.
Wait until you see the solution flowing from the nozzle for
at least 10 seconds which wil prime the line and ensure no
airlocks.
Now push the top switch to
STEAM
, the top light will go
out and the battery LED will remain lit.
If all three LEDs flash at this stage (highlighting an error) turn
off both power switches and repeat this step.
Operations continued
