10 |
P a g e
Rev 10/2012
13.
Place glass D (top) on the top of the unit, align
connecting holes with glass D to glass panels A, B,
and C. Use M6X10 connector bolt to connect. Please
refer to illustration below
14.
Connect the rainfall showerhead water line to faucet,
screw in. Also, connect the light, fan and radio. Then
locate the middle water pipe, which is under the faucet,
and connect it to the steam box water inlet. Secondly,
connect the black steam line, which is on the side of
the steam box, to the steam outlet. Connect steam box
drain line to the steam outlet drain. Finally, connect
the cold and hot water lines to the water manifold, the
red one is for hot water,
while the blue is for
cold.
A: Steam outlet
B: Main Control box
C: Black steam hose
(insulated)
D: Diverter
E: Rainfall shower head
supply
F: Hose clamps
G: M4×25 screw
H: Hose clamp
At this point, you should have all electric & water
features connected!
15.
(
M-A6020 & M-A6023 ONLY
) Align glass E in slot of
base, align the installation holes of glass E to the holes
of Glass D and Glass A. Glass E has a black stripe
long the top and side. Use the Angle Bracket &
Connector Bolt; apply connector bolt caps after final
adjustments. Attach the Door Panel G that has a black
stripe along the top.
16.
(MA6027 & MA6028 ONLY) Attach glass panel E
which has a black stripe across the top and side to
glass panel D and A.
17.
(M-A6027 & M-A6028 ONLY) Insert the corner seal
and corner brackets on the left side of glass F (will
have holes for door hinge) attach to panel D & C with
angle brackets and connector bolts. Attach door
hinges and door Panel G.
18.
Put the wood floor grids in the shower tray and
benches in the unit. Attach flexible waterline to outlet
on panel A and the other end to the handheld shower
wand. Attach to the bracket. Note: the hex nut of the
water line goes on the panel outlet.
