Page
9
Operating Instructions:
1.
Enter the Walk-in Tub, close the door and fill the bath at least 3 inches below the
overflow before activating the pump.
2.
The pump will be activated by the on/off control. Each depression of the button
changes cycles. Do not repeatedly/rapidly press the switch. It may take a few
seconds before an energized system is visible.
3.
Adjust the direction and rate of flow for each jet to your liking by moving the nozzle
for direction and turning either the outside right or the nozzle clockwise or counter-
clockwise for flow (some jets adjust the flow with the outside ring and some with the
nozzle).
4.
If your Walk-in Tub is equipped with a heater, the heating element will automatically
turn on when the whirlpool is turned on. The heater is designed to maintain the
water temperature longer.
5.
If any factory installed fittings are removed, do not operate the unit. A safety hazard
may be present.
6.
Do not use bubble bath when any pumps are operating.
7.
Bath oils may be used; however their frequent use will require more frequent cleaning
of the systems.
8.
Both air and whirlpool systems are plumbed so that water will drain from the
plumbing after each use.
9.
There are no user serviceable parts located under the tub.
Note: Do Not open the Walk-In Tub door while water is still in the tub.
In-Line Heaters
If your bath is equipped with an optional in-line heater it will operate only when the pump
is on. It is always on when the whirlpool pump is on. Note: the in-line heater is designed
to keep your water warm longer but is not designed to increase the water temperature.
Heat settings are not adjustable.
Summary of Contents for MG-304
Page 5: ...Page 5 ...
Page 6: ...Page 6 ...
