SYSTEM INITIALIZATION
1.
After connections are completed, make sure power and water are on.
2.
Turn on timer and allow suffi cient time for unit to react.
3.
Timer can be turned off manually before set time has elapsed.
INSTALLATION, OPERATION & MAINTENANCE MANUAL
CLASSIC SERIES TIMER INSTALLATION
1.
Turn power off at circuit breaker or fuse panel.
2.
Timer should be located on a wall outside the steam room, 5’ away.
3.
Run 14 AWG wire from back of timer 1-NO and 1-C to T1 & T2 on terminal block inside steam generator.
4.
Insert wired timer into a 2-1/2” (min) deep wall box with
“TOP”
indicated on front cover in proper position.
5.
Fasten to wall box using the two (2) screws supplied.
6. Fasten the wall plate to the timer using the two (2) screws supplied with the plate. The screws must be self-
tapped into the timer body and will require gentle inward pressure while fi rmly turning the screw.
7.
Position small plastic timer dial so that
“OFF”
is in the up position. Install the hex nut and tighten.
8.
Push knob onto timer shaft, handle facing down.
2½” min
Step 4
Step 2
Step 5
Step 6
Step 7
STEA
M-WH
IRL
Spa Kur Therapy
Development
Inc
H-e-a-t Spa Kur Therapy Development Inc — Tel 707-942-6633 — Fax 707-942-0734 — www.h-e-a-t.com
14/20
