PRODUCT INFORMATIONS
1. Hanger hook
2. Connecting rod
3. Clothes-hanger
4. Clips
5. Telescopic pole
6. Iron holder
7. Iron
8. Steam button
9. Temperature adjust knob
10. Hose
11. Hand screw
12. Safety cap
13. Unit body
14. Drain plug
15. Ironing board
16. Support pole
17. Power switch
18. Power cord
19. Supporting foot
20. Fabric brush
21. Funnel
22. Measure Cup
Model No.: SAG399
Rating: AC120V 60Hz, 1600W
Water Tank Capacity: 1000ML
Assembly your
Pressurized Garment Steamer
1. Take the unit and all the other parts out of the
package, then check and be sure all the parts are
available reference the Figure 1 show.
2. Fully extend the telescopic pole by open the clips
and loosen the poles, then fully extend the pole, at
last close the clips on the pole and to lock the poles.
As (figure 2) shows. Make sure that the pole is
securely locked into place and cannot be pushed
down.
NOTE: The Telescopic Pole must be fully
extending (3 sections) during steamer operation
to insure enough height for steam clothes.
3. Insert the bottom of the telescopic poles
into the
pole base (see Figure 3), and make sure the pole
not move.
4. Fix the Iron holder on the telescopic pole (see
Figure 4), and attach the steam nozzle on its holder
like the figure 5 shows.
Caution: Do not upside down the nozzle like the
(figure 6) show, it is very dangerous due to the
Nozzle easy fall off
.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
