Problem Solving Guide
PROBLEM
CAUSE
SOLUTION
The unit fails to
steam. The light on
the Pedal Switch
does not
illuminate.
Steamer is not plugged
in.
Plug into electrical outlet.
Household Circuit
Breaker/Ground Fault
Interrupter is tripped or
Fuse is blown.
Reset the Circuit Breaker/Ground
Fault Interrupter, or replace the
fuse.
If you need assistance, contact a
qualified electrician.
The unit fails to
steam. The light on
the Pedal Switch
does
illuminate.
Mineral buildup in the
unit.
Follow the
cleaning ways
Procedure in this manual.
The Water Tank is
empty.
Refill the Water Fill Tank
using the
procedures in this manual.
Water drips from
nozzle
Temperature setting is
too low.
Follow the temperature setting
procedure in this manual re-setting
the temperature.
Burn the clothes
Temperature setting is
too high.
Follow the temperature setting
procedure in this manual re-setting
the temperature.
Ironing board Installation Instructions
1.
All parts for ironing board are as followings:
Big Board*1 Joint plate*1 Instructions*1
Cloth Cover *1 M8Screw*2
2.
Insert the joint plate to the hole of the big board as picture 1 shows.
Note: let the plate feet aiming at the holes of the big board, which will be easier
to install.
3.
Pull the stand foot of the ironing board to 90 degree, and fixed; Loosen clip and
extend the pole, then lock the clip. Refer to picture 2.
4.
Fix the ironing board to the telescopic poles, aim at the holes and screw the M8
screws by hand as picture 3 shows.
5.
Put the two supported poles of the ironing board onto the extension poles like
picture 4 shows.
Picture 1 Picutre2 Picture3 Picture 4
