u
sIng
your
F
abric
S
teamer
Top Innovations
11
OPERATING YOUR
FABRIC STEAMER
NOTE: Be sure that Water Tank has been filled and, if desired, the Fabric Brush is connected
before following these steps.
1.
For first-time use, remove protective plastic cover that is shipped on electrical plug. Plug power
cord into a convenient 3-prong electrical outlet (FIGURE 8-A).
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly
installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this safety
feature in any way.
2.
Set Lighted On/Off Switch to “ON” position (FIGURE 8-B), and verify that switch is illuminated.
3.
After approximately 40 seconds of heating time, unit will begin producing a flow of steam from
Steam Nozzle.
NOTE: It is common for the unit to produce gurgling sounds and small amounts of water
during the first few minutes of steaming. This is a natural part of the steaming process.
Pointing Steam Nozzle towards the ground and shaking it may help to remove excess water
from Hose more quickly (FIGURE 8-C).
4.
Once steam flow is steady and excess condensation has been removed from Hose, you may
proceed with your steaming tasks. Refer to
Tips for Using Your
Fabric Steamer
section on Page
12 for more information about steaming garments and other fabrics.
CAUTION: Always be sure that Steam Nozzle is pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
5.
When you are finished using the
Fabric Steamer
, immediately set Lighted On/Off switch to “OFF”
position and unplug power cord from electrical outlet. Refer to
Care and Storage Guidelines
on
Page 13 for proper cleaning and storage procedures.
FIGURE 8
A
B
C
