a
ssembLIng
your
F
abric
S
teamer
Top Innovations
7
TELESCOPIC POLE
The Telescopic Pole is made up of four sections (FIGURE 1):
•
TOP (SECTION 1)
•
MIDDLE-TOP (SECTION 2)
•
MIDDLE-BOTTOM (SECTION 3)
•
BOTTOM (SECTION 4)
SECTIONS 1, 2 & 3 are adjustable in length. By using the three extension locks, these sections
may be extended or retracted in order to achieve the desired length. Refer to
Adjusting Telescopic
Pole
section below for more details.
NOTE: SECTION 4 (BOTTOM) is the widest section of the Telescopic Pole. This section
includes the COUPLING, which secures the Telescopic Pole to the Pole Base.
ADJUSTING TELESCOPIC POLE
In order to adjust the length of SECTIONS 1, 2 & 3 of the
Telescopic Pole:
1.
Release extension lock directly below SECTION 1 by
swinging hinge outward as shown. SECTION 1 above
it can then be extended / retracted (FIGURE 2).
2.
Once SECTION 1 is at desired length, close hinge to
once again secure extension lock.
3.
Repeat
STEPS 1 & 2
for SECTIONS 2 & 3 of the
Telescopic Pole, using the extension lock directly below
each of those sections.
NOTE: It is recommended to extend Telescopic Pole to
its full height during steamer operation in order to
insure a free flow of steam through the Hose.
FIGURE 2
FIGURE 1
