10 | ENGLISH
Using Your
3-in-1 Steam Mop
FILLING WATER TANK
NOTE: Do not turn unit upside-down when Water Tank is full - a small amount of water may leak
out.
1.
Slide the Water Tank Release Button upward (Figure 1) and hold as you remove Water Tank. Pull
Water Tank upwards and towards you to remove.
2.
Remove Water Tank Cap by unscrewing it in a counter-clockwise direction to unlock. Pull Water
Tank Cap out (Figure 2). Fill Water Tank with room temperature water, up to 15 oz. (444 ml.), and
replace Water Tank Cap so that the grooves on top and bottom of Water Tank Cap align with the
tabs inside Fill Hole. Screw Water Tank Cap in a clockwise direction to lock (Figure 3).
3.
Slide the Water Tank Release Button upward and hold. Insert Water Tank inside the cavity of Mop
Body (inserting and aligning the bottom of Water Tank first). Push Water Tank forward until locked
into place.
NOTE: In order to significantly reduce mineral build-up and prolong the life of your 3-in-1
Steam Mop, use of distilled or de-mineralized water in the unit is highly recommended. Refer
to Page 15 for more information about mineral build-up.
NOTE: The tube that transfers water from the Water Tank to the boiler is weighted down with
a brass ball. This is an intentional design to improve efficiency of water usage. It is normal for
this ball to create a rattling sound inside of Water Tank during use.
If you think brass ball has come loose from tube, refer to troubleshooting guide on Page 16.
FIGURE 1
FIGURE 2
FIGURE 3
Water Tank
Release
Button
