ENGLISH | 11
GENERAL OPERATION
NOTE: Be sure that Water Tank has been filled and all
desired accessories are connected before following these steps.
1.
For first-time use, remove protective plastic cover that is shipped on
electrical plug. Plug power cord into a 120V grounded electrical outlet.
2.
Press the Power Button to turn the unit On. Power Indicator Light will
immediately illuminate to indicate that unit is powered on and heating.
Select desired steam setting (Default setting is Level 4). Increase the
steam setting by pressing the "+" button or decrease the steam setting
by pressing the "-" button.
NOTE: Steam settings are broken down by intensity (Levels 1 - 7 with
Level 1 “LOW” setting, Level 7 “HIGH” setting and Level 4 “DE-
FAULT” setting) as well as function (“MOP/FABRIC” & “HANDHELD CLEANER”). Refer to Page
13 for more information about selecting steam settings.
3.
After approximately 30 seconds, you will hear a buzzing sound as unit begins to emit steam.
4.
Direct Steam Nozzle (with any connected accessories) towards surface you wish to steam. Refer to
Steam Mopping
section below, as well as
Fabric Steaming
and
Steam Cleaning
sections on Page
12 for further details.
CAUTION: Always be sure that Steam Nozzle and any accessories are pointed in a safe direction
(away from yourself, other people, pets and plants) when steaming.
STEAM MOPPING
NOTE: It is recommended to sweep or vacuum floors before mopping.
• Make sure Extension Pole, Mop Head and a Microfiber Pad are all properly connected. Refer to
Pages 6 & 7 for details.
• Follow General Operating Instructions above to begin steaming.
• Mop using a steady back-and-forth motion over the floor, working your way backwards in order to
avoid walking over the freshly mopped area.
NOTE: To avoid warping or damage caused by heat and moisture, do not use on unsealed
hardwood or unglazed ceramic surfaces. Care should also be taken when steaming sealed hard-
wood floors, as prolonged exposure to steam in a single spot may cause damage and discol-
oration. To avoid this, keep the 3-in-1 Steam Mop in constant motion on these surfaces. Steam
may remove the sheen from some floors that have been treated with wax.
Surfaces that are not properly sealed may be warped or damaged by exposure to heat and moisture.
Before steaming any flooring, it is recommended to consult the manufacturer’s guidelines. For flooring
in question, always test on a small inconspicuous area before proceeding.
• The Microfiber Pad will absorb moisture during mopping. However, depending on floor surface and
steam intensity setting, some residual moisture may be left behind. In this case, it is recommended
to allow floor time to air-dry. A fan may be directed towards mopped area to facilitate drying.
