6 | ENGLISH
STEAM MOP SETUP
EXTENSION POLE
1.
Connect Handle to upper, wider end of Telescopic Pole. To do this, simply slide Handle onto Tele-
scopic Pole until it locks into place (Figure 1-A).
2.
Insert lower, narrower end of Telescopic Pole into Mop Body (Figure 1-B). Make sure Release
Button aligns with the small hole on Mop Body. Press Telescopic Pole until Release Button snaps
through small hole on Mop Body. Telescopic Pole should now be secured to Mop Body.
NOTE: In order to coax Release Button through hole, it may be necessary to rotate and adjust
Telescopic Pole until button aligns properly with hole.
3.
To adjust the height of Telescopic Pole, press and hold Extension Lock downward (Figure 1-C).
While holding Extension Lock down, move Telescopic Pole until it is adjusted to the desired height.
Release Extension Lock, then move Telescopic Pole again until it “clicks” securely into place.
4.
To disconnect Telescopic Pole for storage, press firmly on Release Button on Mop Body while simul-
taneously pulling Telescopic Pole upward from Mop Body (Figure 1-D).
NOTE: Increasing length of Extension Pole may provide additional leverage for easier,
more effective steam mopping.
Assembling Your
3-in-1 Steam Mop
FIGURE 1-A
FIGURE 1-B
FIGURE 1-C
FIGURE 1-D
