ENGLISH | 7
MOP HEAD
CAUTION: Always allow unit to cool before connecting/disconnecting any accessories.
1.
Align Mop Head with main unit as shown (Figure 2).
2.
Slide Mop Head neck into Steam Nozzle, pressing firmly until release button snaps through hole.
3.
To remove Mop Head, press firmly on release button while simultaneously pulling Mop Head
away from Steam Nozzle.
MICROFIBER PADS
1.
Lay one Microfiber Pad on flat surface, with two fastener
strips facing upward.
2.
Align Mop Head above Microfiber Pad. Make sure Mop
Head is oriented with Pad as shown, and centered as best
as possible (Figure 3).
3.
Press Mop Head firmly down onto Microfiber Pad. Fastener
strips will adhere to pad grips on underside of Mop Head.
Pad should now be attached and ready for use.
CAUTION: Use care when handling a recently used
Microfiber Pad, as it may still be hot.
NOTE: Microfiber Pads are machine washable. To avoid
picking up lint, washing separately from other fabrics is
recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recom-
mended; machine drying on a low setting is acceptable
as well.
HOLE
FIGURE 3
RELEASE
BUTTON
FIGURE 2
MOP HEAD
NECK
STEAM
NOZZLE
