Steamfast SF-623, Owner'S Manual

Using the

Mid-size Fabric Steam Press

6 | ENGLISH

FILLING WATER RESERVOIR

1.  Place Mid-Size Fabric Steam Press on a flat, level surface.

2.  Turn Locking Knob to “Unlock” position to unlock Pressing Plate.

3.  Lift up Pressing Plate using Handle. It will automatically stay in lifted position.

4.  Pull Water Reservoir out. Note that Water Reservoir cannot be completely removed from unit; 

  do not attempt to force it free.

5.  Using Measuring Cup (included), fill Water Reservoir up to the 150ml (5.07 oz) line with

   water. 

OPERATION

1.  With Pressing Plate in lifted position, plug power cord into  

  electrical outlet, and set On/Off Switch to “On” (I) position  

  (FIGURE 1).

2.  Identify type of fabric you are going to press, and select  

  corresponding temperature setting using Temperature Control 

 Dial. Note that it is best to start with the most delicate fabrics    

 first, as higher levels of heat will cause damage to Nylon and 

 Silk. Pressing Indicator Light will illuminate.

3.  A few minutes of heating time will be required to reach  

  selected temperature. Once Pressing Plate is heated,   

  Pressing Indicator Light will deactivate.You are now ready

  to begin pressing.

4.  Lay fabric flat on Ironing Board.

5.  If pressing wool, cotton or linen you may choose to spray with a burst of steam. This function 

 is available once Steam Burst Ready Indicator Light illuminates.

NOTE: Do not activate burst of steam with unit completely closed, as this may damage 

unit. Best results are obtained if Pressing Plate is held open approximately 3 in. (75 mm.) 

above Ironing Board before pressing Steam Burst Button. For safety reasons, do not hold 

Pressing Plate open more than 3 in. (75 mm.) when using steam burst function. Only use 

burst of steam for 2-3 seconds for best results. If press is left on fabric for more than 10 

seconds, it could result in damage to the fabric.

NOTE: When using the nylon or silk settings, no steam is produced.

6.  To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there for 8-10  

  seconds, then lift up Pressing Plate. Repeat until you have achieved desired crease and  

  smoothness. See page 7 of this manual for more specific pressing tips.

7. Once pressing tasks are complete, immediately set On/Off Switch to “Off” (O) position and 

 unplug power cord from electrical outlet. Refer to page 8 of this manual for further

  information about cleaning and storage of Mid-Size Fabric Steam Press.

FIGURE 1