background image

2 | ENGLISH

WARNING

•  To reduce risk of burns, electrocution, fire, or injury to persons: Do not 

tamper with or modify this product in any way. The manufacturer assumes no 

responsibility for damage or injury caused by failure to follow these instructions, 

improper use, or unauthorized product modification. Any such actions will 

invalidate the product warranty. 

•  To reduce the risk of electric shock, this appliance has a polarized plug (one 

blade is wider than the other). This plug will fit in a polarized outlet only one 

way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not 

fit, contact a qualified electrician to install the proper outlet. Do not change the 

plug in any way.

1.

 Use Home & Away Steam Iron only for its intended purpose as indicated in these 

instructions.

2.

 Do not use an extension cord to operate this unit.

3.

 Before plugging power cord into electrical outlet, be sure that all electrical 

information on rating label agrees with your power supply.

4.

 To reduce likelihood of circuit overload, DO NOT operate another high wattage 

appliance on the same circuit as this unit.

5.

 To protect against risk of electrical shock, do not immerse unit in water or other 

liquids. Do not use power cord as handle, allow it to hang over edge of counters, 

or be crimped or closed in doors. 

6.

 The iron should always be turned OFF before plugging or unplugging from 

outlet. Never yank power cord to disconnect from outlet; instead, grasp plug 

and pull to disconnect. Always keep unplugged when not in use.

7.

 Do not operate unit with a damaged power cord or if the unit has been dropped 

or damaged. To avoid risk of electrical shock, do not disassemble unit; take it to 

a qualified service repair person for examination and repair. Incorrect reassembly 

can cause a risk of electrical shock when unit is used.

8.

 Close supervision is required for any appliance being used near children, pets 

and plants. Do not leave unit unattended while plugged in.

9.

 This unit is not intended for use by persons (including children) with reduced 

physical, sensory or mental capabilities, or lack of experience and knowledge, 

unless they have been given supervision or instruction concerning use of the unit 

by a person responsible for their safety.

10.

 If Heating Indicator Light does not illuminate when Temperature Control 

Dial is turned to one of three heat settings, unit is not operating normally. 

Immediately unplug and have unit serviced by qualified service personnel.

11.

 Unplug power cord before filling or emptying Water Tank.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING

Summary of Contents for SF-717













Reviews: