background image

®

2

1

3

4

5

1

Control panel (S170-1, S170-3)

007-1347

2

Data cable

007-1348

3

Temperature sensor

007-1350

4

Circuit board

007-1351

5

Contactor 40 A

007-1352

Instructions for Installation and Use

3. Instructions for Installation

Figure 11 - Reset button of the overheat protector

4. Spare Parts

Steamist Limited Warranty

06/11

Pub. No. 572-C

- 8 -

3.4 Resetting the Overheat Protector

The sensor box contains a temperature sensor and a 
overheat protector. The temperature sensor senses the 
temperature and the resettable overheat protector cuts off the 
heater power in case of a malfunction after which the 
protector can be reset. See Figure 11.

NOTE: The reason for the overheat must be determined 
before the button is pressed.

Residential Applications

Steamist will replace any defective components in their sauna 

heaters, contactors, controls, used in residential applications, for the 
period of 5 years from the original purchase date. This limited 
warranty covers faults in manufacture and material only, and includes 
the exchange of new parts supplied by the manufacturer or the 
manufacturer’s agent, after the defective parts are returned to 
Steamist. The replacement of parts under warranty does not extend 
the warranty period beyond the original five year period. In addition, 
Steamist will perform the required labor to repair or install the 
component, at the factory, for the period of one year from the original 
purchase date. All costs for removal and reinstallation of the 
component(s) on the job site, shipment to the factory and shipment 
back to the job site will be the responsibility of the owner of the 
equipment. 
Commercial Applications

Steamist will replace any defective components in their sauna 

heaters, contactors, controls used in commercial applications, for the 
period of one year from the original purchase date.

This limited warranty covers faults in manufacture and material 

only, and includes the exchange of new parts supplied by the 
manufacturer or the manufacturer’s agent, after the defective parts 
are returned to Steamist. The replacement of parts under warranty 
does not extend the warranty period beyond the original one year 

period. In addition, Steamist will perform the required labor to repair 
or install the component, at the factory, for the period of one year from 
the original, purchase date. All costs for removal and reinstallation of 
the component(s) on the job site, shipment to the factory and 
shiprrient back to the job site will be the responsibility of the owner of 
the equipment. This limited warranty does not cover damage to the 
heater caused by normal wear and tear, damages caused by 
improper installation, improper use and care or alterations made to 
the sauna product.

This limited warranty is void if the heater is used improperly. 

Chemically treated water, such as spa or pool water should not be 
poured over the sauna stones. The sauna room must be heated for a 
minimum of 30 minutes prior to the application of water to the sauna 
stones. The limited warranty is void if a shower or faucet has been 
installed in the sauna. Damages resulting from the misuse of the 
heater will not be covered in the warranty. 

This limited warranty is void if the installation and wiring is not 

performed by a certified electrician or authorized and qualified service 
representative.

The limited warranty applies only to the original purchaser and 

installation of the product. 

A return authorization number assigned by Steamist is required 

prior to returning any product for repair. Components returned without 
a return authorization number may not be repaired or replaced. 

East Coast Office: 25 E. Union Ave., East Rutherford, NJ 07073 • Tel: 800-577-6478 • Fax: 201-933-0746
West Coast Office: Tel: 800-355-6478 • Fax: 661-940-1617 

®

 

Summary of Contents for S170-1









Reviews: