background image

®

®

®

®

START

1

START

2

STOP

CR2032

CR2032

Front

View

Rear
View

1

2

3

4

LEARN

1

2

4

4

Bottom View

3

Installation and Operating Instructions

Remote Features and Operation

(See Figure 1)

1. The blue transmit indicator light will illuminate any 

time a button is transmitting a signal. If this light 
should stop functioning, replace the batteries.

WARNING: Never press the Start button unless you are 
certain the steam room door is closed. Continuous opera-
tion of the steam bath with the door open can damage the 
home.  

2. The Start 1 & 2 buttons are used to selectively start 

the preprogrammed user 1 or user 2 settings on the 
TSC control. Simply press the appropriate button to 
start the cycle. 

3. The Stop button cancels or stops the cycle. Simply 

press the stop button to cancel the started cycle. 

4. The pre-installed batteries should last approximately 

one year depending on usage. Replace with (2) 
CR2032 batteries if necessary.

Receiver Features and Operation

(See Figure 2)

1. Red Learn indicator light.

2. Learn button is used to pair additional remote 

controls. To pair additional controls or to pair the 
control that came with the receiver, first press the 
learn button and the learn indicator will light. While 
the indicator is lit press any button on the remote to 
complete the pairing process. The learn button will 
flash and go off indicating a successful pair. After 
testing the operation press the Stop button and 
make sure the TSC control has not been uninten-
tionally started.  

3. Cable connection jack. 
4. Mounting holes 

02/09

Pub. No. 205-A

Total Sense Remote Control Option

Figure 1: Remote Control

Model: TSR

- 1 -

Figure 2: Receiver

The Total Sense Remote Control is designed to work exclusively with the Steamist Total Sense TSG generators and 
TSC controls. The control transmitter sends radio frequency signals to the receiver through walls and floors to the 
receiver. The range of the transmitter by comparison is very similar to a garage door opener. The receiver comes with 
25 feet of wire allowing the receiver to be located within the vicinity likely to use the transmitter.

®

C

US

®

Summary of Contents for TSR

Page 1: ... Operation See Figure 2 1 Red Learn indicator light 2 Learn button is used to pair additional remote controls To pair additional controls or to pair the control that came with the receiver first press the learn button and the learn indicator will light While the indicator is lit press any button on the remote to complete the pairing process The learn button will flash and go off indicating a succe...

Page 2: ...e are four connection jacks in TSG generator s and two in each of the other optional features allowing for gangable connections in the most convenient arrangement The manner in which everything is interconnected is not important only that everything is interconnected 3 Mount the receiver securely on a wall with the antenna in a vertical position for the best reception Installation and Operating In...

Page 3: ...s with Part 15 of the FCC Rules This device has not been approved for use in Canada Package Includes 1 TSR Remote Control 1 TSR Receiver 1 25 Control Cable 2 CR2032 Batteries Required Equipment TSG generator TSC Control Installation Notes Centrally locate receiver where transmitter is likely to be used Route cable to the TSG generator TSA AromaSense Module or TSC Digital Control Module Mount recei...

Page 4: ...Control Wireless Receiver iPod Cradle TSC Control CONTROL CABLE CONTROL CABLE TSC Digital Control Module Aroma Box MENU 1 2 110 F STEAM 112 03 38 17 112 Aroma Injection Tee TSS CL Invisible Speakers TSS CL Classic Speaker East Coast Office 25 E Union Ave East Rutherford NJ 07073 Tel 800 577 6478 Fax 201 933 0746 West Coast Office 315 W Pondera St Suite F Lancaster CA 93534 Tel 800 355 6478 Fax 661...

Reviews: