Steba IK 500, Instructions For Use Manual

15

∙

Attention! Do not place hot pots or pans onto the con-
trol panel! Not warranty payments!

∙

Do not carry the unit when the pot or the pan is on it.

∙

Do not use the device if unsupervised. Oil and fat can 
catch fire if they get too hot.

∙ Do not place near objects which are affected by magnet. (e.g. 

automatic-banking cards).

∙ Unplug the device after every use (not if built-in!)

∙

Attention!
Device gets hot!
Risk of burns!

∙ While using the device, the surface can get very hot. Place the 

device with a distance of at least 70 cm to burnable materials 
(e.g. curtains).

Cleaning

∙ Clean after every use

∙ Unplug the device and wait until cooled down.

∙

Never immerse the device into water and never run water 
over the unit. Pay attention that no liquids can get into 

the device through the air inlets.

∙ A discoloration or storing can be caused if pots are used which 

are not clean at the bottom.

∙ Use a damp cloth and some detergent for cleaning.

∙ Do not use any abrasive milk, polishing wool or solvent for clea

-

ning.

∙ Use vacuum cleaner to suck up dirt from the air intake and ex

-

haust vent.

Installation

∙

The device must not be placed on a table, but must be installed into a table 

top!

∙

In order not to damage the electronics, sufficient cold air must come to the sides 

and from below to the device.

∙ It must be guaranteed that the ventilation slots are not polluted.

∙

The enclosed sealing stripes should be glued between the glass plate and the table 
top.