13
Getting started
∙ Unwind the cable from the cable storage und plug it in.
∙ Open the lid, fill the device with water and close the lid.
∙
Do not fill the above the maximum marking on the water gauge because
hot water can escape.
∙ Place the container onto the base, the device beeps 2 times and the LED shines.
∙ Press the ON/OFF button, the red LED shines.
∙ The device starts with the 100°C mode and starts heating. Once the temperature is
reached, the device beeps twice and the red LED turns off.
∙
Setting the temperature:
o Choose the desired temperature 50, 70, 80, 90°C with the selection button.
A LED indicates the corresponding temperature.
o Press the OON/OFF button, the device starts heating.
o Once the temperature is reached the device beeps twice and the red LED
turns off.
∙
Keeping warm function:
o If the set temperature should be kept for 30 minutes, press the ON/OFF
button for 5 seconds during the setting process. The red and blue LED
shine. The devices turn off after 30 minutes.
Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with pro-
blems that may occur when using your device. For many problems there is a simple
solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem
Reason
Solution
Control light does
not shine once de-
vice is plugged in
∙ No power
∙ To many devices at one
power cord
∙ Check is plug is plugged-in
correctly
∙ Check the fuse
Boiling result is bad
∙ Lid is not closed properly
∙ Heating plate is calcified
∙ Close the lid
∙ Decalcify the device
Device turns off
∙ Due to scale, heat accumu-
lates and triggers the mi-
croswitch
∙ Leave to cool for 10 min-
utes.
∙ Descale
